User`s guide

Section 360−381−S02

Step System ResponseAction

3. Check the box beside the channel number(s) you

are using.

4. Select OK Initiates the loopback or release. Results will be

displayed in the alarm status area of the main

screen (see Figure 18).

Note: A loopback channel can be “forced busy”. However, a loopback test cannot be performed on a channel

that is busy.

Figure 21. E&M Card Loopback

7.1.3. Loopback of FXO/FXS Card

Use the following steps to perform the FXO/FXS card loopback (this is a network loopback).

Step Action System Response

1. Select Loopback Test " Loopback of FXO/FXS

Card

Opens the FXO/FXS Loopback/Release dialog

box (see Figure 22).

2. Select the Loopback or Release tab.

3. Check the box beside the channel number(s) you

are testing.

4. Select OK Initiates the loopback or release.

Note: A loopback channel can be “forced busy”. However, a loopback test cannot be performed on a channel

that is busy.