User`s guide

Section 360−381−S02

Use the following steps to change time slot allocation. Time slots and chassis slots must be unallocated before

they can be allocated. The first three steps are followed to unallocate chassis slots (channels) from time slots. the

last two steps are followed to allocate chassis slots (channels) to time slots.

Step Action System Response

1. Click Delete.

2. Click on the chassis slot that you want to change

and respond Yes when asked to confirm.

The chassis slot will turn white, and its corre-

sponding T1 time slot(s) will darken.

3. Repeat steps 1 and 2 for any other chassis slots

you want to unallocate.

4. Click on the unallocated chassis slot you want to

allocate.

The selected chassis slot will turn yellow.

5. Click on the T1 time slot you want to allocate the

chassis slot to.

Note: For chassis slots that use multiple time

slots, click on the first T1 timeslot to be

used.

The selected chassis slot and time slot(s) will turn

light green.

Note: If a chassis slot does not have a card plugged in, the chassis slot channels will not be displayed.

5.5 Time Slot Mode (only with Secondary T1 Unit Installed)

Use this dialog box to change data that will be sent to a T1 time slot that is not allocated on the other T1. Chang-

ing the time slot mode provisioning does not affect the operation of the channel bank unless the T1 is set to nor-

mal (drop & re-insert) mode.

Note: Time slots that are not dropped must be set to broadcast on both the Primary and Secondary T1 time

slots to pass data from one T1 to the other T1. Time slots to be blocked between T1s should have the

time slot mode set to idle on both Primary and Secondary T1 time slots.

Select Settings"Set Time Slot Mode

Figure 17. Setting the Time Slot Mode