User`s guide

Section 360−381−C02

Menu Selection Use to...

IP Address/Subnet

Mask/MAC Gateway

Address Message

Set IP address, subnet mask and gateway address

Logout Log out of the system.

4. T1 MODULES

4.1 Primary T1 Modules

Most settings can be found under the Primary T1 Module heading.

T1 Card Menu (Primary)

Retrieve and Set T1 Parameters

Alarm Cut Off

Loopback Test for T1

Performance Monitor

System Reset

1 KHz 0dbn0 Test Tone

Set Test Tone

Loopback Test (FXO/FXS/EM)

Loopback Test (Nx64)

Loopback Test (ISDN)

Loopback Test (DSU/OCU)

System Alarm Status

ICB Card RTC Time

Time Slot Allocation Mapping

Figure 4. Primary T1 Menu

Menu Selection Use To...

Retrieve & Set T1 Parameters Retrieve and set the T1 parameters

Alarm Cut Off Turn off current audible alarm

Loopback Test for T1 Run a T1 loopback test

Performance Monitor Retrieve performance information

System Reset Reset the system parameters either to default or to a previous setting

1 KHz 0dbm0 Test Tone Apply an internally-generated test tone to 1 or more channels (FXO/FXS/EM)

Set Test Tone Apply an internally-generated momentary DTMF tone to a channel

Loopback Test (FXO/FXS/EM) Loopback test menu for voice cards

Loopback Test (Nx64) Loopback test menu for Nx64 data cards

Loopback Test (ISDN) Loopback test menu for ISDN data cards

Loopback Test (DSU/OCU) Loopback test menu for DSU/OCU data cards