User`s guide

Section 360−381−C02

8.2 Trap IP Table

Traps must be enabled in this table and through the MIB (instance iadTrapSetProxy under iadTrapMgt) to be gen-

erated by the ICB.

Traps must be enabled using the SNMP manager.

Traps will only be generated based on local system conditions. A local system is any system that is directly con-

nected via an Ethernet LAN to the management network. A “Reset to Factory Settings” will clear the table config-

uration. The SNMP Network Node Manager documentation provides additional information.

Figure 27. Trap IP Table

Parameter Description

Community Enter the name to be used to refer to this equipment

IP Address Enter the IP address of the Trap recipient

Status Traps must be Enabled to be generated.

Applying changes to this table will initiate a warm start and momentarily disrupt T1 service.

Warning

Note: Note: The following eight traps are supported by this equipment:

ACTLPBKLF alarm trap (T1 Line far−end loopback)

ACTLBKP alarm trap (T1 payload far−end loopback)

AIS alarm trap

LOF alarm trap

LOS alarm trap

YEL alarm trap

warm start

authentication trap