User`s guide

Section 360−381−C02
25
Parameter DescriptionOption
DSR Control Yes Force data set ready
No Normal
DCD Control Yes Force data carrier detect
No Normal
Interface Mode 3RS+V/V.35/RS232 Select the interface mode. 3RS+V selects the follow-
ing: RS449, RS530, V.36
Latching Loopback Enable/Disable Enable/disable detection of latching loopback codes
Data Rate 2.4K, 4.8K, 9.6K, 19.2K, 56K,
64K
Transmission data rate. 56K and 64K available in
synchronous (SYN) mode only
Stop Bit Shortened 12.5% or 25% Asynchronous (ASYN) mode shortened stop bits
Parity Bit Yes/No Asynchronous (ASYN) mode only
7/8 Bits Mode 7 or 8 Asynchronous (ASYN) mode only
Stop Bit 1 or 2 Asynchronous (ASYN) mode only
Error Correction Enable/Disable BCH error correction
Zero Code Suppression Enable/Disable Converts zero byte to control code (18 Hex) toward
the network
RTS Force On Yes/No Force request to send ON.
5.6 ISDN Parameters (for 3638-80 Quad Circuit ISDN)
LULT
LULT
LULT
LULT
On
On
On
On
2B+D
2B+D
2B+D
2B+D
None
None
None
None
Mode
Sealing
Current
nB+nD
Composite
CLk Source
Ch13
Ch14
Ch15
Ch16
Figure 21. ISDN Parameter Settings