User`s guide

Section 360−381−C02

Parameter DescriptionOption

Zero Code Suppression Enable/Disable Select to transmit a code if an all-zero byte is detected

Speed Sub. Channel 2.4K, 4.8K, 9.6K, 19.2K,

56K, 64K, SW56

Select transmission data rate for any or all channel slots

Latching LPBK Enable/Disable Available for all data rates

CSU/DSU CSU Converts DSU loopback codes from network to CSU

loopback codes

DSU Normal operation. Allows DSU loopback codes to be

sent.

5.5 DSU-DP Parameters (for 3633-80 12 Channel Data Service Unit—Data Port)

Figure 20. DSU-DP Parameter Settings

Note: Availability of some options depends on the data rate chosen. The maximum data rate for an RS-232 in-

terface is 19.2K.

Parameter Option Description

Channel Selection 1−12 (if in Card 1 slot) Select the channel the parameters will be applied to.

Each channel can be configured individually

13−24 (if in Card 2 slot)

Each channel can be configured individually

25−30 (if in half size slot)

ASYNC/SYNC Mode ASYNC or SYNC Synchronous or asynchronous data transmission

Note: This mode must be selected to set the data

rate.

CTS Control Yes Force clear-to-send

No Normal