User`s guide

Section 360−381−C02

4. Use the arrow keys to highlight the desired direc-

tion and press <Enter>

Asks you which mode you want to set—

Bdct=broadcast or Idle=idle

5. Use the arrow keys to highlight the desired mode

and press <Enter>

Applies the mode to the selected time slot.

5. CHANNEL CARDS 1 & 2 AND HALF SIZE MODULE

Parameters available on these dialog boxes will depend upon what cards you are using in the Card 1, Card 2 and

half size slots.

Note: For complete descriptions of the card parameters, refer to the documentation for the individual cards you

are using.

5.1 FXO Parameters (for 3658-80 12 Channel FXO/DPT Unit)

Use this screen to retrieve and/or change the parameters of the FXO/DPT unit.

Figure 16. FXO Parameter Settings

Parameter Option Description

Channel Selection 1−12 (if in Card 1 slot) Select the channel the parameters will be applied

to Each channel can be configured individually

13−24 (if in Card 2 slot)

to. Each channel can be configured individually

25−30 (if in half size slot)

Channel Impedance 600 ohms Loop matching impedance

900 ohms

Operating Mode FXO/GS FXO—ground start

FXO/LS FXO—loop start

DPT/NORMAL DPT—Normal

DPT/WINK DPT—Automatic wink