User`s guide

Section 360−381−C02

Use the following steps to enable/disable the tone test.

Step Action System Response

1. Select which card you want to test (Card 1, Card 2

or half-size module)

Displays your choice

2. Select the channel number you want to test. Use

the <Tab> key to highlight the channel number and

<Enter> to select the channel

Flags the channel

3. Select the operation setting. Enable starts the test,

and Disable stops it

Note: Disable will stop any enabled test tones on

the selected channel.

Displays your choice

4. Select the direction of the test (XMT or RCV)

Note: XMT is toward the T1.

Displays your choice

5. Select Apply New Settings to save your choices

and enable/disable the test tone

Press <q> to exit the menu without saving your

changes

If you have chosen to enable the tone test, this will

start the test. You will have to go back into this

menu and select Disable to end the test.

4.8 Set Test Tone (Primary T1 Only)

Use this screen to select a channel to be tested with a momentary tone.

Note: This test is valid for voice cards only.

Tone Parameters Menu

Card Type = FXO

Card Type = FXS

Card Type = Unplugged

Select Channel

Apply New Setting

Figure 11. Tone Parameters Menu