User`s guide

Section 360−381−C02
11
4.5.3. Reset PM Data
Use to clear stored data. Select Now to reset data at the current time, or select Today to reset data from the start
of the current day.
4.6 System Reset (Primary T1 Only)
4.6.1. Reset to Stored Values
Performs a system reset using the T1 and card configuration at the time of the reset.
4.6.2. Reset to Factory Default Values
Perform a system reset using the factory default T1 and card parameters. A system reset will clear all configura-
tion information from the Community table and the Trap IP table. Refer to the documentation for each individual
unit for default values.
4.7 1 KHz 0dbm0 Test Tone (Primary T1 Only)
Applies a 1 KHz 0dbm0 test tone for channel setup procedures.
Note: This test is valid for voice cards only.
Figure 10. 1 KHz 0db Test Tone Menu