Specifications

Issue 1.0, April 2006 Section 364-180-N02

2. To edit the currently defined PPP routed service, click “Edit” link for the connection as in the

figure below. Then the edit page will appear.

Figure 6-25 Web Tool – WAN connections page

To edit the service, click on the links at the top of the edit page. The links include:

Edit ‘Service’, Edit ‘PPP’, Edit ‘Hdlc Channel’, Edit ‘Ip Interface’, Edit ‘Rip Versions’, and

Edit ‘Tcp Mss Clamp’.

In “Edit PPP” page, the option fields include:

Server: PPP server true or false. If this is set to true, the router card is configured to be a

PPP server; if false, the router card is configured to be a PPP client.

Note: The two ends of a PPP link must not be PPP servers at the same time.

Create Route: set to true, a route will be created which directs packets to the remote end of

the PPP link.

Specific Route: set to false.

Subnet Mask: sets the subnet mask used for the local IP interface connected to the PPP

transport.

Route Mask: sets the subnet mask used by the route that is created when a PPP link comes

up. If it is set to 0.0.0.0, the subnet mask is determined by the IP address of the

remote end of the link.

Lcp Max Configure: sets the Link Control Protocol (LCP) maximum parameter for an

existing PPPoH transport.

Lcp Max Failure: sets the Link Control Protocol (LCP) maximum fail parameter for an

existing PPPoH transport.

The availability of features and technical specifications herein subject to change without notice.