Specifications

Issue 1.0, April 2006 Section 364-180-N02
©2006 Charles Industries, Ltd.
All rights reserved. Printed in United States of America.
125
Frame Relay - bridged
In this example, the router card bridges between Ethernet and Frame Relay. Frame Relay runs
between the two routers over an HDLC link.
PC A Router A Router B PC B
192.168.0.2
FB Por
t
192.168.0.1
F
B
P
ort
192.168.0.3 192.168.0.4
Configure PC A and PC B
1. Configure PC A as follows:
• IP address: 192.168.0.2
• Subnet mask: 255.255.255.0
• Gateway: None
2. Configure PC B as follows:
• IP address: 192.168.0.4
• Subnet mask: 255.255.255.0
• Gateway: None
Configure Router A using the CLI
1. Clear any existing Bridge interfaces and Ethernet and Frame Relay transports by typing the
following command:
ip clear routes
ip clear rip
ip clear interfaces
bridge clear interfaces
transports clear
port fr set AutoStart false
port fb set AutoStart false
2. Add an Ethernet device to the Bridge. In the following commands, eth0 is the transport name,
ethernet is the port name and bridge1 is the Bridge interface name:
The availability of features and technical specifications herein subject to change without notice.