User's Manual

300SR/ST - OPERATION 27
CHOOSE ANTENNA CONFIGURATION
300SR/ST - OPERATION 27
CHOOSE ANTENNA CONFIGURATION
CHOOSE ANTENNA CONFIGURATION
The 300SR receiver has two antenna configurations:
CHOOSE FREQUENCY
Receiver
Set the 300SR receiver to one of the following frequencies:
• power (50 Hz or 60 Hz)
• radio
• active (8 kHz or 29 kHz)
Transmitter
Your 300ST transmitter was configured at the time of purchase to
send either 8 kHz or 29 kHz signals.
Antenna Description When to use
peak Uses two horizontal
antenna to detect signal.
Response is highest at
strongest signal.
This is the preferred
configuration for most
applications.
null Uses a vertical antenna to
detect signal. Response is
lowest when receiver is
over the line.
Use primarily to verify
the location of a target
line after it has been
located with the peak
antenna.
CHOOSE ANTENNA CONFIGURATION
The 300SR receiver has two antenna configurations:
CHOOSE FREQUENCY
Receiver
Set the 300SR receiver to one of the following frequencies:
• power (50 Hz or 60 Hz)
• radio
• active (8 kHz or 29 kHz)
Transmitter
Your 300ST transmitter was configured at the time of purchase to
send either 8 kHz or 29 kHz signals.
Antenna Description When to use
peak Uses two horizontal
antenna to detect signal.
Response is highest at
strongest signal.
This is the preferred
configuration for most
applications.
null Uses a vertical antenna to
detect signal. Response is
lowest when receiver is
over the line.
Use primarily to verify
the location of a target
line after it has been
located with the peak
antenna.