How-To Guide

If charging does not begin. Adjust the positioning of your phone on the charging
Stand.
If the LEFT LED indicator light of the charging stand start flashing light blue after your
devices is placed on it. Then you should remove your devices, unplug the 3 in 1 Smart
Wireless Charging Stand, and repeat the setup process.
Note: If after you have set up the charging pad again, and the LEFT LED light
continues Flashing LIGHT BLUE when your device is placed on it. Then your Device is
likely not compatible with wireless charging.
3. iWatch Charger holder
You can put your original iWatch Charger through the Front hole.
Press the cable into the gap.
Wind the excess cable into the slot for storage.
Connect the iWatch USB to the USB A port.
Hand your iWatch to the holder, match it with it’s charger.
FCC Statement
This device complies with part 18 of the FCC Rules. Operation is Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modifications not explicitly
approved by the party responsible for compliance could void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 and part 18 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and candidate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface
of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
● Increase the separation between the equipment and any other radio device.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.