Installation manual

C-3
Installing a Bottom Sign on the Wall Mount Retractor
To ensure a proper fit, the bottom sign must have these minimum characteristics:
• Material - Vinyl with a maximum thickness of .03”
• Dimensions - Exactly 4.00” (102 mm) wide and up to 30.75” (782 mm) high
782 +/- 1MM
(30.79”)
101.5 +/- 0.5MM
(4.0”)
2MM PER SIDE SHOULD BE BACKGROUND
COLOR ONLY - MAYBE OBSCURED BY SIGN
RETENTION FEATURES.
A detailed sign specification is available at www.chargepoint.
com.au/support/technical-documents/. Example (not to scale):
The method used to install a bottom sign is the same with or
without the main body installed:
1. Insert one of the long edges into the retractor’s grooves
along the side portion of the retractor.
2. Bend the sign slightly to insert the other long edge.
3. Slide the sign all the way down until the bottom edge is
against the bottom surface on which the station is installed.
Installing a Rear Sign on a Retractor
Installing a sign on the rear side of a retractor is the same as the
instructions provided above for installing a bottom sign on a wall
mount retractor.
Custom and Optional Signs
Detailed sign specifications for custom and optional signs are
available at www.chargepoint.com/support-guides.php
Slide the sign all
the way down
until the bottom
of the sign is flush
with the surface
upon which the
station is installed