Installation manual

B-3
Lift the white lever on the terminal block that corresponds with
the ground connection (center), insert the ground wire, then
push the lever down until it clicks into its fully closed position.
Lift the white levers on the terminal block that corresponds with
the RIGHT port’s L and N connections. Insert the L and N wires
fully into the terminal block, then push the levers down until they
click into their fully closed positions.
NOTE: The connections for the left port are not used. Power for
the left port is carried through the jumpers.
WARNINGS:
• Use copper conductors only.
• Do NOT provide GFCI protection at the panel—the CT4000 has built-in GFCI protection.
• Use breakers rated at 40A (or lower, if you are configuring the station to operate at a lower current capacity as
described on the following page).
• In areas with frequent thunder storms, add surge protection at the service panel for all circuits.
• Use new circuit breakers only. Used breakers can damage equipment and cause a fire risk.
• Ensure all power and ground connections, especially those at the breaker, are clean and tight. Remove all
oxide from all conductors and terminals before connecting wiring.
Step 2: Apply the Electrical Rating labels
Described on page B-5.
Step 3: Complete the station installation
Install the head assembly and top cap as described in the CT4000 Installation Guide.
Step 4: Enable Power Share
Power up the station. If the Installation Wizard displays, follow the onscreen
instructions to enable Power Sharing. If the Installation Wizard does not display,
configure Power Sharing using the Service Menu as described below.
Display the station’s Service Menu:
• if the station is not activated on ChargePoint, simultaneously press and hold the
two leftmost buttons and the rightmost button for two seconds.
• if the station is activated on ChargePoint, scan your ChargePoint Service card.
Select Basic mode.
Scroll down to select Power Sharing Configuration.
Select Enable.
Select Exit to leave the Service Menu.
Confirm that the station’s display indicates that power sharing has been configured.
LEFT
L1
RIGHT
L1
GND
LEFT
L2
RIGHT
L2
The station
indicates that
power sharing
is configured
Press the button
immediately
below the menu
item to choose
the associated
function
If the Installation Wizard does not
display upon power up, simultane-
ously press and hold these three
buttons for two seconds to display
the Service Menu on an unactivated
station