Installation manual

4-10

ChargePoint® Charging Stations

The CT4000 Installation Wizard also includes a procedure for replacing a broken head assembly, which includes these tasks:

• Set language

• Conﬁgure the station for Power Share/Power Select (see Appendix B)

• Check for faults

• Test locking holsters

• Install cable clamps

• Transfer conﬁguration from old station to new head

When using the Installation Wizard to replace a station, it is ready to use when the process is complete. The station owner

does not need to activate the new station.

NOTE - ELECTRIC RATING LABELS

If you are using either Power Sharing to share one circuit for two ports, or Power Select to limit the maximum output power

of the station, the wizard instructs you to apply the appropriate Electrical Rating label. The wizard describes which Electrical

Rating label you must attach to the station.