Installation manual

4-4

ChargePoint® Charging Stations

Step 2: Prepare Head Assembly for Mounting

• To prepare the head assembly for mounting, open

the box and stand the head upright on its foam

packaging, as shown.

• If you are installing a gateway station, install the

Network Enablement Kit:

a) Remove the SIM card from its carrier by pushing

it ﬁrmly.

a) Lift the rubber ﬂap located on the left hand side

of the head assembly, as shown.

b) Insert the notched edge of the SIM card into the

slot, with the notch facing upward. Slide it into the

slot and push it FULLY into the slot until it “clicks”

into place. Refer to the orientation instructions

printed on the side of the head assembly.

TIP! To push the SIM card into the slot, use a corner

of the SIM card’s carrier, as shown.

Remove the SIM card