Installation manual

2-1

Installing a Bollard Mount

Before You Start

Before installing a bollard mount, prepare the installation site as described in Appendix A. After preparing the installation site,

you need the following:

• Ratchet and 3/8” (10 mm) socket*

• 1/2” drive torque wrench and 15/16” (24 mm) 6-point deep socket, for 5/8 (11 /16 mm) nut**

• Adjustable wrench

• Bubble level

• #2 Phillips screwdriver

• Wire stripper

• Voltage tester

*For use with assembled SAE hardware.

**For use with CT4000 Bollard to Concrete Mount Kit (35-001013-01).

Overview of Steps

Installing the bollard mount involves a few simple steps, summarized below and detailed in the remainder of this chapter:

1. Check Boxes for Correct Contents (page 2-2)

2. Prepare Pole/Base Plate for Mounting (page 2-3)

3. Mount Pole/Base Plate (page 2-4)

4. Install Main Body (page 2-5)

5. Prepare Retractor for Mounting (page 2-6)

6. Install Retractor (page 2-7)

7. Connect Wiring (page 2-8)

8. Check Voltages (page 2-9)

When you have completed these steps, you will be ready to install the head and top assemblies as described in Chapter 4.