Installation manual

1 -5
Introduction
Single Port or Shared Power Wiring Diagram
The following illustration describes the wiring for installing a dual port CT4000 on a shared single circuit. For this installation,
you will need the power sharing kit to allow both ports to share a two pole 40A circuit breaker. Wiring connections are
provided in Appendix B. Grounding requirements are described on page 1-6. See Appendix B for lower power operation
options.
Wiring for a dual circuit installation, see the previous page.
TERMINAL BLOCK WITH
POWER SHARING JUMPERS INSTALLED
TERMINAL BLOCK WITH
POWER SHARING JUMPERS INSTALLED
(13 mm)
(13 mm)