Installation manual

C
C-1
Installing and Replacing Signs
Follow these steps in this section to install signs onto the charging station. To ensure a proper fit, signs must follow the
specification provided by ChargePoint. An example of the sign specification (not to scale) is provided below. Detailed sign
specifications are available at www.chargepoint.com/support-guides/. To ensure a proper fit, a replacement sign must be a
maximum of 1 mm thick, 102 mm wide and 514 mm high.
Installing a Front Sign on a Bollard
It is easier to install the sign before installing the head assembly, but it can be installed with
the head assembly already in place. Follow these steps to install the sign with the head
assembly in place. If the head assembly is not installed, the installation steps are the same,
with the exception of inserting the top edge of the sign under the bottom lip of the head
assembly.
• Remove the tape from the
adhesive strip on the back of the
sign.
• With the adhesive strip facing
toward the bollard, insert the
top left corner of the sign under
the groove on the top left corner
of the bollard, sliding the sign
upwards as far as possible to
position the top of the sign
under the bottom lip of the head
assembly.
• Starting with the top left corner
and working from top to bottom,
use a thumb or finger to slide
the left side of the sign under the
bollard’s leftmost groove.
• When the left side of the sign is
fully inserted, bow the top of the
sign outward slightly to insert the
top right corner of the sign under
the groove on the top right corner
of the bollard, ensuring the top of
sign remains positioned under the
bottom lip of the head assembly.
• Starting with the top right corner
and working from top to bottom,
use your thumb or finger to slide
the right side of the sign under
the bollard’s rightmost groove.
• When the sign is fully inserted
into the bollard’s left and right
grooves, and under the bottom
lip of the head assembly, run your
hand down the center of the sign
while applying enough pressure
to make sure the sign’s adhesive
strip contacts the bollard.