Installation manual

3-8
ChargePoint® Charging Stations
Step 7: Install Main Body
• Expose the pre-drilled hole located below the terminal
block. To do so, push the tab on the terminal block to
release the cover plate, then slide the cover plate upwards
until it stays in position:
• Remove the pre-installed flange bolts from the front
brackets.
• Position the main body so that the top hole aligns with
the top retractor bracket.
• Re-insert a 3/8 - 16 x 3/4” flange bolt into the top hole
and finger tighten.
• Re-insert the other flange bolt into the lower mounting hole.
• Tighten both flange bolts to 50 in-lbs (117 Nm).
• Connect the conduit and run wiring through the conduit
and into the main body of the station.