Installation manual

C-2
ChargePoint® Charging Stations
Installing a Top Sign on the Retractor
To remove a sign after the station has been installed:
1. Use the L-wrench to loosen the set screw on each side
of the top cap, as shown.
2. Pull the top assembly up and move it towards the
back of the retractor.
3. Slide the existing sign out of the grooves.
To install the new sign:
1. Slide the replacement sign into the grooves by
bending is slightly.
2. Slide the sign all the way down, ensuring its bottom
edge is located behind the plastic cap on the
retractor’s extrusion, as shown.
3. Re-install the top assembly. Remember to tighten the
set screws.
Bend the sign
slightly to insert it
into the grooves
Slide the bottom
edge of the sign
until it is positioned
behind the plastic
cap