Installation manual

B-5
For 16A Circuits For 24A Circuits
If both ports are sharing a single circuit
(and you have therefore installed the
jumpers), you must use the power
sharing label from the bottom row
Electrical Rating Label
on Top Cap
For Shared 30A
Circuits
Apply the Electrical Rating Label
Step 1: Choose the appropriate label
Step 2: Apply a label to the terminal block cover
Apply a label to the left side of the terminal block cover,
just above the terminal block.
NOTE: Leave the terminal block cover in the raised
position to facilitate connection of the head assembly.
Step 3: Apply a label to the top cap
Apply the corresponding label to the right side of the
Top Cap, behind the cable exit.