Installation manual

4-16
ChargePoint® Charging Stations
Post-Installation Checklist
Before leaving the installation site, complete this checklist for each radio group. Then tear out this page and give it to the
person responsible for activating the station. If installing multiple radio groups, use one page for each radio group (this page
is included in all CT4000 Installation Guides).
þ
Check each box below to confirm that the task has been completed for all stations within the radio group.
¨
All mounting hardware is tightly secured and all stations are level and rock solid.
¨
The two security screws inside the holster plugs on all head assemblies are tightened and the rubber plugs are in
place.
¨
Cable retractors:
• Cable clamp halves are assembled and screwed together with no gaps.
• All charging cables operate smoothly through full extension and retraction.
¨
Voltages at all power plates have been verified with a solenoid type voltmeter (such as a Wiggy):
• Line-to-Line measures 208/240VAC.
• Line-to-Earth measures 120VAC.
¨
If Power Share Jumpers are installed:
• All jumpers are fully inserted. Look for 1/8” (3 mm) depth.
• Power Share mode has been configured, using the on-screen Installation Wizard, for all power-shared stations
and the station’s display indicates that power sharing is in effect.
• The supplied Electrical Rating label has been applied above the terminal block and on the top cap as described
in Appendix B.
¨
If Power Select is applied:
• Power Select has been configured using the on-screen Installation Wizard.
• The supplied Electrical Rating label has been applied above the terminal block and on the top cap as described
in Appendix B.
¨
All steps of the Installation Wizard have been completed and that the station is currently showing the animation
screen (illustrated on page 5-1), which describes how to use the station.
¨
The radio group has been documented for activation by attaching the spare activation labels to the previous page.
"
After completing both sides, cut or tear along dotted line and give it to the person responsible for activating the station.