Installation manual

4-12
ChargePoint® Charging Stations
Step 6: Secure Head Assembly
Remove the L-wrench by rotating it to the right until the
security tag breaks. Lift the head assembly slightly and
remove the L-wrench.
IMPORTANT: If applicable, ensure the snaps
on the top cap are fully engaged before lowering
the head assembly. If they are not fullly engaged,
the head assembly will not be properly seated. See
page 4-5.
Lower the head assembly. Ensure the head assembly is
fully seated and that no gap exists between the bottom
of the head assembly and the main body. The head
assembly fits tightly and may require extra downward
force to ensure it is fully seated.
Using the L-wrench, tighten the two security set screws,
located inside the holsters, to approximately 25 to 30 in-
lbs (2.8 to 3.4 Nm).
Cover the screws using the two rubber plugs.
Insert the charging plugs into their corresponding
holsters.
You have now finished the physical installation of the
CT4000 charging station and are ready to prepare the
station for activation on ChargePoint.