Installation manual

4-11
Installing the Head and Top Cap
NOTE - POWER MANAGEMENT KIT
If you are using Power Sharing to allow both ports on a dual port station to share a single 40A circuit, the wizard instructs
you to install the jumpers that are provided in the optional Power Management Kit (ordered separately). For more information
on Power Sharing, see Appendix B.
NOTE - CABLE CLAMPS
The wizard describes how to install the cable clamps, which are included in the shipping box with the Cable Management Kit.
For more information, see Appendix D.
STARTING A CHARGING SESSION
A ChargePoint card is attached to the front page of this Installation Guide. Use this card to authorize a charging session. Make
sure that both plug holsters unlock and that the station displays instructions on how to plug into the vehicle.
NOTE: The ChargePoint card supplied on the front cover can authorize up to ten charging sessions.
If you have performed the above steps, and the station operates as described and no errors exist, continue with the
installation. If any of the above conditions are not met, resolve the error before continuing by referring to Chapter 5,
Troubleshooting.