Installation manual

2-5
Installing a Bollard Mount
Step 4: Install Main Body
To install the main body:
• Align the notches on the rubber spacer with the front
mounting nuts, then slide it all the way down the
pole until it is flush with the base plate. This prevents
any rocking motion between the main body and the
base plate.
• Slide the body over the mounting pole.
• Re-tighten the screws you loosened in Step 2 to
approximately 80 in-lbs (9 Nm) using a 3/8” (10 mm)
socket wrench.
IMPORTANT: Ensure the body is firmly aligned to
the bottom surface and that no movement (rocking) can
take place, even when significant pressure is applied.
IMPORTANT: The bollard is designed to shed
moisture between its bottom surface and the concrete
pad. It is very important to maintain this moisture egress
feature so that there is no unwanted moisture build up.
Therefore, do not seal the bollard to the concrete pad
with caulking, silicone or other sealing material.
Position
notches
(2) at
front
Re-tighten the 2 screws