Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
1-4
ChargePoint® Charging Stations
Dual Circuit Wiring Diagram
The following illustration describes the wiring for installing a CT4000 on a dual circuit. Wiring for a single circuit installation is
described on the next page. Grounding requirements are described on page 1-6.
NOTE: Requires two dedicated circuits, each with its own two pole 40 A breaker.