Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
C-5
Simultaneously press and hold
these three buttons for two
seconds to display the Service
Menu on an unactivated station
Press the button
immediately below
the menu item to
choose the
associated function
Step 4: Configure the Station for Power Sharing
Follow these steps to allow the station to be powered by a single circuit:
1. Display the station’s Service Menu:
• If the station is not activated on ChargePoint,
simultaneously press and hold the two leftmost
buttons and the rightmost button for two seconds.
• If the station has been activated, scan your
ChargePoint Service card
2. Select Basic mode.
3. Select Power Sharing Configuration.
4. Select Enable.
5. Select Exit to leave the Service Menu.
6. Confirm that the station’s display
indicates that power sharing has been
configured.
The station
indicates that
power sharing
is configured