Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
C
C-1
CT4000 Power Sharing Instructions
A CT402X provides 30A of charging to each port when connected to two 40A circuits, or it can be configured to allow both
ports to share one 40A circuit. To allow both ports to be powered by a single 40A circuit, you must complete the steps
provided this appendix. You will need the supplied power sharing kit (CT4020-PSHARE), located in the shipping box with the
station’s main body. The power sharing kit contains:
Before you start
Before installing the power sharing kit, complete the installation instructions for the main body (see Chapter 1 or 2), but do
not connect the wiring.
Overview of steps
Installing the power sharing kit involves a few simple steps, summarized below and detailed in the remainder of this appendix:
1. Install the Jumpers (page C-2)
2. Connect the Wiring (page C-3)
3. Apply the Electrical Rating Label (page C-4)
4. Configure the Station for Power Sharing (page C-5)
Jumpers (2) Electrical Rating label