Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
B
B-1
Removing or Replacing the EV
Charging Sign
The method used to remove and/or replace the EV Charging Sign differs depending on whether the station has been
installed. Both methods are described in this appendix.
To ensure a proper fit, a replacement sign must have the following characteristics, at a minimum:
• Material - Vinyl with a maximum thickness of .03”
• Dimensions - Exactly 4.00” (102 mm) wide and up to 20.25” (514 mm) high
A detailed sign specification is available at www.chargepoint.com/support-installation-guides.php. Example of sign
specification (not to scale):
102.5 ± 0.5 mm
(4.00”)
514 ± 1 mm
(20.25”)
261 mm
(10.28”)
During Station Installation
1. After removing the retractor from the shipping box,
remove the existing sign before mounting it. Insert
your finger or a screwdriver underneath the bottom
edge of the sign to pull it out of the retractor’s
grooves.
2. To install a new sign, bend it slightly and insert it into
the grooves.
insert finger or
screwdriver to pull
existing sign out
of its grooves