Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
4-11
Installing the Head and Top Cap
Step 7: Secure Head Assembly
To secure the head assembly:
• Remove the T-25 L-wrench by rotating it to the right
until the security tag breaks. Lift the head assembly
slightly and remove the L-wrench.
• Lower the head assembly. Ensure the head assembly
is fully seated and that no gap exists between the
bottom of the head assembly and the main body.
The head assembly fits tightly and may require extra
downward force to ensure it is fully seated.
• Using the T25 L-wrench, tighten the two security set
screws, located inside the holsters, to approximately
25 to 30 in-lbs.
• Cover the screws using the two rubber plugs.
• Insert the charging plugs into their corresponding
holsters.
You have now finished the physical installation of the CT4000 charging station and are ready to prepare the station for
activation on ChargePoint. See Chapter 5.