Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
4-10
ChargePoint® Charging Stations
Step 6: Install Cable Clamps
IMPORTANT: Do not unwrap the ropes until they are securely
attached to the charging cable.
To install the cable clamps:
• Locate the bead at the end of the retractor rope.
• Uncoil the charging cable by removing the plastic wrap, then
gently extending it all the way out, away from the station. Rotate
the plug as necessary to remove any twists or kinks. Locate the
tape that marks the position where the clamp attaches to the
cable.
• Hold the charging cable with the marked tape positioned under
the retractor top, as shown. Ensure the charging cable does not
touch the ground when fully retracted.
• Insert the bead inside the clamp, then snap the opposite side of
the clamp into place.
• Secure the two sides of the clamp together by inserting the four
screws and tightening them securely using a Phillips screwdriver.
• Repeat the above steps for the other charging cable (if
applicable). If installing a single port station, allow the left
(unused) rope fully retract into the top cap.
• Pull down on the rope and remove the rope from its wrapper.
When the rope is unwrapped, it retracts into the top cap.
IMPORTANT: Check that the charging cable extends and
retracts fully and smoothly. If it doesn’t, see page 6-5.
Position
tape under
retractor
top