Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
4-9
Installing the Head and Top Cap
Step 5 cont’d: Verify Station Operates Correctly
3. Use the ChargePoint card attached to the front cover of this Installation Guide to authorize a charging session. Make sure
that both plug holsters unlock and that the station displays instructions on how to plug into the vehicle.
NOTE: The ChargePoint card supplied on the front cover can authorize up to ten charging sessions.
If you have performed the above steps, and the station operates as described and no errors exist, continue with the
installation. If any of the above conditions are not met, resolve the error before continuing by referring to Chapter 6,
Troubleshooting.