Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
4-4
ChargePoint® Charging Stations
Step 2: Prepare Head Assembly for Mounting
• To prepare the head assembly for mounting, open
the box and stand the head upright on its foam
packaging, as shown.
• If you are installing a gateway station, install the
Network Enablement Kit:
a) Remove the SIM card from its carrier by pushing
it firmly.
a) Lift the rubber flap located on the right hand side
of the head assembly, as shown.
b) Insert the notched edge of the SIM card into the
slot, with the notch facing upward. Slide it into the
slot and push it FULLY into the slot until it “clicks”
into place. Refer to the orientation instructions
printed on the side of the head assembly.
TIP! To push the SIM card into the slot, use a corner
of the SIM card’s carrier, as shown.
Remove the SIM card