Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
3-8
ChargePoint® Charging Stations
Step 7: Install Main Mody
• Expose the pre-drilled hole located below the terminal
block. To do so, push the tab on the terminal block to
release the cover plate, then slide the cover plate upwards:
• Position the main body so that the top hole aligns with
the top retractor bracket.
• Insert a 3/8 - 16 x 3/4” flange bolt into the top hole and
finger tighten.
• Insert the other flange bolt into the lower mounting hole.
• Tighten both flange bolts to 150 in-lbs.
• Connect the conduit and run wiring through the conduit
and into the main body of the station.