Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
3-6
ChargePoint® Charging Stations
Step 5: Mount Retractor
To mount the retractor assembly:
• Place the two front brackets where you can easily
reach them.
• Tilt the retractor up against the rear brackets, with
the front of the retractor facing towards you, as
shown (mount holes visible).
NOTE: The bottom of the retractor should rest on the
ground.
• Place the top front bracket over the two
corresponding screws protruding from the top rear
bracket. You’ll need to steady the retractor with one
hand, while using the other hand to position the
bracket.
• Repeat for the bottom bracket.
• Tighten all four screws to 60 in-lbs using the Phillips
screwdriver.
• Insert the slot cover, bottom first, into the slot at the
bottom of the retractor.