Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
3
3-1
Installing a Wall Mount
Before You Start
You need the following:
• Drill and Tap for appropriate wall attachment hardware
• Attachment hardware, such as 3/8” (9.5 mm) x 3” (76 mm) lag bolts if mounting to a wood wall
• Ratchet and 9/16” deep socket
• #2 Phillips screwdriver
• Tape measure
• Bubble level
• Marker
• Wire stripper
• Multimeter
Overview of Steps
Installing the wall mount involves a few simple steps, summarized below and detailed in the remainder of this chapter:
1. Check Boxes for Correct Contents (page 3-2)
2. Drill Holes in Wall (page 3-3)
3. Mount Rear Brackets to Wall (page 3-4)
4. Prepare Retractor for Mounting (page 3-5)
5. Mount Retractor (page 3-6)
6. Install Conduit (page 3-7)
7. Install Main Body (page 3-8)
8. Connect Wiring (page 3-9)
9. Check Voltages (page 3-10)
When you have completed these steps, you will be ready to install the head and top cap as described in Chapter 4.