Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
2-4
ChargePoint® Charging Stations
Position a level at various
locations, both horizontally
and vertically, including over
each bolt
Align the longer curved
edge to where you want
to position the front of the
station
Adjust the lower nuts as
necessary to ensure the
pole/base plate is level
When
level,
tighten the
upper nuts
Step 3: Mount Pole/Base Plate
Prepare the installation site as described in Appendix A,
then mount the pole/base plate assembly as follows:
• Pull wires through conduit.
• Place the pole/base plate assembly over the conduit,
ensuring the long curved edge of the base plate is
located where you want the front of the charging
station located.
• Adjust the lower nuts as necessary to ensure the
mounting pole is level.
• When level, tighten the nuts on top of the base plate
to at least 115-120 ft-lbs.
IMPORTANT: Ensure the pole/base plate is level
by adjusting the nuts underneath the base plate. Verify
accuracy after each adjustment by positioning the level at
various locations on the pole, above each bolt.