Installation Manual
Table Of Contents
- Front Cover
- Table of Contents
- Introduction
- Installing a Bollard Mount
- Installing a Wall Mount
- Installing the Head and Top Cap
- Preparing the Station for Activation on ChargePoint
- Troubleshooting
- Appendix A: Preparing the Installation Site for a Bollard Mount
- Appendix B: Removing or Replacing the EV Charging Sign
- Appendix C: CT4000 Power Sharing Instructions
- Appendix D: Limited Product Warranty
2-3
Installing a Bollard Mount
Step 2: Prepare Pole/Base Plate for Mounting
• Use a 3/8” socket wrench to loosen (but not remove)
the two screws holding the pole inside the bollard.
• Remove the pole/base plate assembly from the main
body by pulling it out from the bottom.
• Remove and discard the cardboard shipping spacer.
Loosen the 2 screws
(don’t remove)
Rubber
bumper
Pole
Base
plate