Owner`s manual

OM5050E.2 ™ & © Char-Griller / A&J Mfg. 20
Step 18
Before attaching WARMING RACKS you must attach the warming rack pivot BOLTS
to the GRILL HOOD and BODY. Insert the 1½” BOLTS through the holes in the sides
of the HOODS from the outside and tighten the HEX NUTS on the inside of the
HOODS. Insert the 1½” BOLTS through the holes in the sides of the GRILL BODIES
from the outside and tighten the HEX NUTS on the inside of the GRILL BODIES. Now,
you can attach the warming racks to these bolts as shown below and secure with
HEX NUTS only finger tight.
Step 19
Set the POT STAND in place over the SIDE BURNER. Next install the three (3) FLARE-
UP SHIELDS over the BURNER TUBES then hang the FIRE GRATE/ ASH PAN from the
FIRE GRATE HANGERS on the catch tabs that are welded to the inside of the CHAR-
COAL GRILL BODY sides.
Pot Stand
Fire Grate Hangers
Fire Grate/Ash Pan
Flare-up Shields
1 1/2”
Inside of
Hood
Hex Nut
1 1/2”
Hex Nut