Owner`s manual

OM5050E.2 ™ & © Char-Griller / A&J Mfg. 15
Step 10
Insert the IGNITER WIRES, which are attached to the underside of each BURNER,
through the same hole in the GRILL BODY that the BURNER goes through and then
attach the WIRE to the backside of the ELECTRONIC IGNITER, which is attached to
the back side of the CONTROL PANEL. Any wire can go into any of the three sockets
on the Electronic Igniter.
Burner
Igniter Wire
Electronic Igniter
Step 9
Install the MAIN BURNERS into the GRILL BODY by first inserting the open end of
the BURNERS through the holes in the front of the grill body. Making sure the VALVE
tips are inside the burner tubes. The BURNER with the longest wire is installed on
the right side of the GAS GRILL BODY. Secure the BURNER to the GAS GRILL BODY
with the SCREWS provided.
Valve
Burner