Product guide

II l cAuTioN
r
SPIDER ALERT!
SPIDERAND WEBS
iNSiDE BURNER
If your barbeque is getting hard to light or
the flame is weak, check and clean the
venturis and burners.
Spiders or small insects are known to create
"flashback" problems by building nests and
laying eggs in the barbeque's venturi or
burner obstructing the flow of gas. The
backed-up gas can ignite behind the control
panel. This flashback can damage your
barbeque and cause injury. To prevent
flashbacks and ensure good performance,
the burner and ventud tube assembly should
be removed and cleaned whenever the
barbeque has been idle for an extended
period of time.
Storing Your Grill
, Clean cooking grates.
* Store in dry location.
* When LP cylinder is connected to grill, store outdoors in a well-
ventilated space and out of reach of children.
* Cover grill if stored outdoors. Choose from a variety of grill
covers offered by manufacturers.
* Store grill indoors ONLY if LP cylinder is turned off and
disconnected, removed from grill and stored outdoors.
* When removing grill from storage, follow "Cleaning the Burner
Assembly' instructions before starting grill.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas OFF at control knobs and LP cylinder.
2. Remove cooking grates and flame tamers.
3. Remove carryover tubes and burners.
4. Detach electrode from burner.
NOTE: Removal/Detachment method will depend on the
burner configuration. See different configurations in
illustrations below.
5. Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works welt)
into a small hook. Run the hook through each burner
tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
6. Wire brush entire outer surface of burner to remove food
residue and dirt.
7. Clean any blocked ports with a stiff wire such as an open
paper clip.
8. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
VERY iMPORTANT'.Burner tubes must reengage valve
openings. See illustrations at right,
9. Attach electrode to burner. Correct
burner-to-valve
10. Carefully replace burners, engagement
11. Attach burners to brackets on firebox.
12. Reposition carryover tubes and attach
to burners. Replace flame tamers and
cooking grates.
Firebox
burner
bracket
Electrode
;off
electrode with
a flat blade
screwdriver