Use and Care Guide

PRESSURE GAUGE AND BALL VALVE ASSEMBLY
11
WAND TUBING TO MANIFOLD
12
Install wand tubing (C-7) to manifold as shown using supplied hose clamp (C-3).
Install pressure gauge (C-1) and ball valve (C-2) to output manifold as shown.
Insert lead wire assembly into plug at rear of pump. Join
red wire of the lead wire to a +12V source on the garden tractor. The black wire should be grounded or connected to the negative battery post.
C-1
C-2
1E
C-3
C-7
NOTE: Do Not over-tighten pressure gauge.