Assembly Instructions
Suggested Tools:
Wrench and/or Ratchet Set
Approximate assembly time is 5-10 minutes
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
• Remove bottom bolt from each side of handle (below triangle shaped thumb screws)
• Loosen thumb screws and ip up handle
• Replace bolts below thumb screws and tighten down
• Tighten thumb screws completely
Handle
Bolts
Thumb
Screws
Figure A
* Note: If spring detaches from bail assembly,
simply re-attach (see Figure A).
Completed
Assembly
ASSEMBLY INSTRUCTIONS
• Be sure gate control is in the closed position (do not hold bail down when lling)
• Determine appropriate setting for material being used by reading the suggested setting on the material’s bag.
Be sure to read the instructions on the bag/box of the material you’re spreading to identify accurate setting needed)
• To begin spreading, start walking (about 3 mph pace) and pull the bail system down to open gate
• To stop spreading simply let go of the bail and the gate will close
GENERAL OPERATING INSTRUCTIONS
BAFFLE OPERATING INSTRUCTIONS
• Adjust bae by hand to block distribution accordingly. Front and sides can be adjusted independently.
• Use wing nuts to adjust tension on baes.
AUGER INSTALLATION
• Screw auger onto impeller sha. Screw auger retaining nut into auger hole with M6
socket driver. Tighten completely with wrench to secure.