Use and Care Manual

Suggested Tools:
Wrench and/or Ratchet Set
Approximate assembly time is 5-10 minutes
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
•Removebottomboltfromeachsideof
 handle(belowtriangleshapedthumbscrews)
•LoosenM6Hexnutsandipuphandle
•TightenM6Hexnutscompletely
Handle
Bolts
M6 Hex
Nuts
Figure A
*Note:Ifspringdetachesfrombailassembly,
 simplyre-attach(seeFigureA).
Fully Assembled
WARNING
Auger is designed to work in forward motion. Excessive reverse motion could cause binding. If
resistance is felt while pulling spreader backwards, stop and clear salt from auger.
ASSEMBLY INSTRUCTIONS
Note: Model 81000A Does
not include baffle system.