Use and Care Guide

4E
Stage 3
(removable
Shut-off filter)
FILLING THE SPRAYER
Makesurethefilterbasketisinplacetokeepdebrisfromenteringthetank.
Determine the amount of mixture needed for your application. Add the proper amount of water to
the tank. Add the proper amount of chemical to the tank (check the chemical label for proper ratio of
chemical).Stirmixtureintankwithacleanutensil(likeapaintstirrer).Thetankwillholdthe4-gallon
(15.1L)capacityplusthechemical.
Itisnotnecessarytocompletelyfillthesprayertankwitheachuse.Youcanfillthetankwithonlythe
amount needed for each application.
Always follow the manufacturer’s instructions included on their product label.
Figure 1
Stage 1
(Filter
basket)
3 STAGE FILTERING SYSTEM
Stage 2
(Removable
In-Tank Filter
Pressure
Cylinder
Thisbackpacksprayerisequippedwitha3stagefilteringsystem(seefigure
1).Stage1isafilterbasketincorporatedintothetankopeningwherefluidis
added.Stage2filterislocatedattheinletofthepressurecylinder.Stage2
isaremovableIn-Tankfilter.Stage3isaremovablefilterincorporatedinto
theshut-oassembly.Periodiccleaningofthesefiltersisrecommendedto
insureconsistentfluidflowthroughthesprayer.Thiswillalsoreducesprayer
component wear.
Thestage3filterisaremovablefilterincorporatedintotheinletsideofthe
shut-ovalve(seesection“disassemblingandrepairingtheshut-ovalve”).
Makesurepressureisreleasedbeforedetachingthehosefromtheshut-o.
Itisbesttohavenoorminimalfluidinthepressurecylinderbeforeremoving
andreinstallingthestage3shut-ofilterasfluidcanleakfromthehose.
Figure 2 Stage 2 (removable In-Tank filter)
Guide edge facing away from
pressure cylinder
Guide edge on pressure
cylinder
SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND HOLDER
The wand easily snaps into
handle.