Use and Care Guide

3E
The backpack strap is provided with
multiple features including shoulder
strap, chest strap, waist belt and lumbar
support.(figure1).Thetoptheshoulder
strap is attached to the top of the tank
and is removable. The hook from the
lumbar support attaches to the base tube
onthebottomofthetank(figure2).
INSTALLING THE SHOULDER STRAP
Hook
Chest
Strap
Lumbar
Support
Waist
Belt
Figure 1
Strap Assembly
Base
Tube
Lumbar
Support
Figure 2
Hook Attachment
Shoulder
Strap
SPRAYER COMPONENTS & USE INFORMATION, Continued
O-ring
Wand
Retaining Nut
Shut-off
Valve
WAND ASSEMBLY
1.Makesuretheo-ringisinstalledontheendofthewand.Insertthewandintoshut-ovalve.
2.Turnandtightentheretainingnutclock-wiseontotheshut-ovalve.
Figure 1 Figure 2
Line up holes
Figure 3
Slide bolts through holes
Figure 5
Right Hand
Figure 4
Tighten nut to bolt
Threaded Bolt
Nylon Lock Nut
Pump
Handle
Pump
Shaft
Completed Assembly
A. Pump Shaft
B. Bolts
C. Pump Handle
D. Nuts
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A). To
install the pump handle place the handle (C) over the shaft (A) aligning the
pump handle holes and shaft holes. Slide the bolts (B) through the aligned
holesasshowninfigure3.Tightennuts(D)tobolts.Thereareholesinthe
pumphandletoallowforeitherleft(fig.2-4)orright(fig.5)handmounting.