Use and Care Guide

DISASSEMBLING AND REPAIRING THE SHUT OFF VALVE

1)Assembledshut-ovalve(Figure1).

2)Removetheretainingpin(A)(Figure2)placethenotchedend

of the retaining pin on a hard surface and push down. Remove the

retainingpinandslidethehandleothevalve.

3)Removetheretainingnut(o-ringattached),spring,andvalvestem(B)

(Figure3).Replacewornparts.LubricatetheO-ringsandreassembleby

reversing the steps above. Place the handle groove in the slotted area of

the valve stem and make sure the locking clip is positioned in the neutral

position(see“HelpfulSprayingInformation”section).Inserttheretaining

pin. Push down on the handle a few times to distribute the lubricant

evenly.Checkﬁlter(C)inendofshut-ovalvefordebris.Removeﬁlter

andﬂushwithwatertocleanout.

Figure 3

Figure 1

Figure 2

Valve

Stem