User`s manual
DVR USER MANUAL - Issue 3 - 12/2013 | 34
CHANNEL SAFETY SYSTEMS t: 0845 884 7000 | w: www.channelsafety.co.uk
5.3.23 Alarm Set
Record Channel: The record channel will be activated when the object move is detected.
Post Recording: You can set how long alarm record will last when alarm ends (30s, 1minutes, 2minutes, 5minutes).
Copy: Allows you copy current channel parameters to any other channel or all channels.
Picture 5-43
The channel will be separat
ed into a 44x36 grids (PAL/NTSC mode). When
any object moves into the motion detection area, and the area where the
object is located is displayed in red and motion detection will be triggered. In
the semi-transparent area the motion detection is not activated.
After conguring the above parameters, click <OK> to save it.
Click [Main Menu - Alarm - Alarm In] to enter into the menu shown in Picture 5-44. Now you can adjust alarm setting based on dierent
variables.
Alarm Type
No.:
Allows you to select a specied channel
I/O Status: Allows you select the three options – NO (Normal Open),
NC (Normal Close) and OFF. Set to “Normal Open”, I/O status Alarm will be
activated while sensor is ON; set to “Normal Close”, I/O status alarm will
be activated while sensor is OFF; set to “OFF”, I/O status alarm will not be
triggered.
Alarm out: Allows you to connect the external alarm sensor.
Latch time: You can set how long when the buzzer will sound when
external sensor alarm is detected (10s, 20, 40s, 60s);
Show Message: You can set show message on the screen when a
sensor alarm is detected.
Buzzer time: you can set how long the buzzer will sound when sensor alarm is detected (O, 10s, 20, 40s, 60s);
Send Email: Allows you to set the alarm images to be sent to a specied email.
Full screen Alarm: The function is defaulted to “On”. When motion detection or an external alarm is triggered, the corresponding
channel will be switched to the full screen mode.
Record Channel: Allows you to select the channels you want to record.
Post Recording: You can set how long the alarm record will last when the alarm ends (30s, 1minute, 2minutes, 5minutes);
Copy: Allows you to copy all the settings from one channel to other.
Picture 5-44